Instructions / Assembly

ASSEMBLY

Figure 15

Attach The Miter Gauge

1. Attach the Miter Gauge (3) by placing it over the

front edge of the table and tighten in place using

the Miter Lock Knob (D) as shown in Figure 15.

Install Table Extension

Install Side Splash Tray

1. The Table Extension (17) installs on the

right side of the Worktable (4).

2. Position the Table Extension so that the two Pegs (A) line up

with the Holes (B) on the Worktable as shown in Figure 12.

3. Secure the Table Extension to the Worktable

by tightening the Thumbscrew located under the

Table Extension as shown in Figure 13.

1. Place the Side Splash Tray (18) to

align with the Table Extension.

2. Secure the Side Splash Tray to the Table

Extension by tightening the Thumbscrew (C) under

the Side Splash Tray as shown in Figure 14.

Figure 12

Figure 13

Figure 14