Instructions / Assembly

ManualsBrandsDelta ManualsFlooringCruzer 13 Amp 7 inch Wet Tile Saw

MAINTENANCE

Checking the Bevel

Cleaning the Pump

Removing the Water Nozzle

1. Position the worktable (4) so that it is under the blade.

2. Loosen the blade cover lock knob.

3. Swing the blade cover (9) open.

4. With the bevel indicator at 0 degrees, use a framing square

to ensure the blade is square with the table.

5. If the blade is not square to the sliding table, adjust the

positive stop screw (A) in the direction that the blade needs to

move in order to square it to the table. Use a small square to

check blade to table squareness.

6. Repeat steps 4 and 5 with the bevel indicator set 45 degrees

and using the 45 degree positive stop (C).

7. To adjust pointer (B) to align to 0° or 45° mark on scale

loosen screw on pointer and adjust to align to correct mark

and re-tighten screw.

8. Close the blade cover and re-lock

The pump shaft cannot be removed.

If the water from the pump is reduced

or has stopped, replace the pump or

have it repaired by the qualified personnel.

Remove the front plate and the impeller, and use a small brush

or stream of water to clean up any debris.

Some dust created by power sanding,

sawing, grinding, drilling, and other

construction activities contains chemicals known [to the State

California] to cause cancer, birth defects or other reproductive

harm.

Some examples of these chemicals are:

It may be necessary to remove or replace the nozzle. If so use

perform the following steps:

1. Use the on-board Allen wrench (5b) to loosen the cap screw

(C).

2. Flip the retaining arm (D) up and release the nozzle and

hose assembly.

3.Grasp the hose and pull the nozzle firmly to disconnect the

nozzle from the hose.

• Lead from lead-based paints.

• Crystalline silica from bricks and cement and other masonry

products.

• Arsenic and chromium from chemically treated lumber.

Yourrisk fromtheseexposuresvaries, depending on how

often you do this type of work. To reduce your exposure to

these chemicals: work in a well ventilated area, and work with

approved safety equipment, such as those dust masks that are

specially designed to filter out microscopic particles.

Figure