Instructions / Assembly

18 19

ADJUSTMENTS

Before performing any adjustments, make sure the tool is unplugged from the power supply and the switch is in

the OFF position. Failure to heed this warning could result in serious personal injury.

This saw has been adjusted at the factory to make accurate

cuts. However, should your tile saw need adjustment after it

has been unpacked and assembled or due to machine wear,

the following steps will be used to align the table to the saw

blade.

NOTE: Do not start any adjustment until you have check

alignment with a square and made a test cut to ensure that

adjustments are needed for your tile saw.

To Square the Cutting Wheel to the

Table

Do not loosen any screws for this adjustment until you have

checked alignment with a square and made a test cut to

ensure that adjustments are needed for your tile saw.

• Unplug the saw.

• Use the provided Allen wrench to loosen hex socket bolts

(A) on the left rail.

• Place a framing square against the worktable fence and

flat part of the blade.

• Using Allen wrench to turn set screw (B) to adjust. Move

the rail until the fence is square with the blade. (Set

screws (B) are located on the outside ends of the rail.)

• Tighten the end hex socket bolts (A) to lock rail in place.

Then tighten remaining hex socket bolts (A).

Figure

Framing Framing

SquareSquare