Installation Sheet

ManualsBrandsDelta ManualsBar FaucetsLeland Single-Handle Bar Faucet with MagnaTite Docking in SpotShield Stainless

Write purchased model number here.

Escriba aquí el número del modelo comprado.

Inscrivez le numéro de modèle ici.

You may need/Usted puede necesitar/

Articles dont vous pouvez avoir besoin:

Para instalación fácil de su llave Delta

usted necesitará:

• LEER TODAS las instrucciones completamente

antes de empezar.

• LEER TODOS los avisos, cuidados, e

información de mantenimiento.

For easy installation of your Delta

faucet you will need:

• To READ ALL the instructions completely

before beginning.

• To READ ALL warnings, care, and maintenance

information.

Pour installer votre robinet Delta

facilement, vous devez:

• LIRE TOUTES les instructions avant de débuter;

• LIRE TOUS les avertissements ainsi que toutes

les instructions de nettoyage et d’entretien.

Models/Modelos/Modèles

9132-DST, 9178-DST, 9192-DST,

9678-DST, 9932-DST, 9992-DST,

16971-DST, 19922-DST,19949-DST,

19978-DST & 19992-DST

Series/Series/Seria

11/4/16 Rev. Awww.deltafaucet.com

WARNING: THIS FAUCET IS NOT TO BE USED WITH PORTABLE

DISHWASHERS!

ADVERTENCIA: ¡SESTA LLAVE NO SE DEBE UTILIZAR CON MAQUINAS

LAVAPLATOS PORTATILES!

AVERTISSEMENT: ON NE DOIT PAS BRANCHER UN LAVE-VAISSELE

PORTATIF SUR CE ROBINET!

HIGH-RISE PULL-DOWN KITCHEN AND

BAR / PREP FAUCETS

LLAVES DE AGUA ELEVADAS, DESLIZABLES

HACIA ABAJO, PARA COCINAS Y BARES / PREP

ROBINET À COL DE CYGNE ET BEC-DOUCHETTE

POUR ÉVIER DE BAR OU D’ÎLOT DE CUISINE

1/8" (3.17mm)

91888

Summary of content (20 pages)

PAGE 1
HIGH-RISE PULL-DOWN KITCHEN AND BAR / PREP FAUCETS LLAVES DE AGUA ELEVADAS, DESLIZABLES HACIA ABAJO, PARA COCINAS Y BARES / PREP ROBINET À COL DE CYGNE ET BEC-DOUCHETTE POUR ÉVIER DE BAR OU D’ÎLOT DE CUISINE 91888 Models/Modelos/Modèles 9132-DST, 9178-DST, 9192-DST, 9678-DST, 9932-DST, 9992-DST, 16971-DST, 19922-DST,19949-DST, 19978-DST & 19992-DST Series/Series/Seria Write purchased model number here. Escriba aquí el número del modelo comprado. Inscrivez le numéro de modèle ici.
PAGE 2
1 19949-DST 19992-DST, 9992-DST & 9192-DST 5 5 5 3 4 3 3 3 19978-DST, 9178-DST, 9678-DST, 9132-DST & 9932-DST 3 3 4 2 8 2 8 8 3 2 2 1 1 4 6 6 1 6 7 7 9 7 9 9 Models 19949-DST, 19992-DST, 9992-DST, 9192-DST, 19978-DST, 9178-DST, 9678-DST, 9132-DST & 9932-DST Place gasket (1) into groove on bottom of base ring (2). Place base ring onto sink over mounting hole, then install trim ring (3) over base ring.
PAGE 3
Optional / Opcional / Facultative 16971-DST & 19922-DST 2 2 4 1 3 3 2 1 5 3 2 4 5 6 1 3 3 4 2 5 3 6 5 7 6 Optional Escutcheon Installation Model 16971-DST & 19922-DST Place gasket (1) into groove on bottom of faucet (2). Insert faucet tubes and mounting shank (3) through mounting hole. Install mounting bracket (4) and nut (5) onto the mounting shank using wrench (6). Not included with all models - To order see replacement parts page for your model.
PAGE 4
2 A. B. OR 5 2 O 3 4 OU 2 5 1 2 2 4 1 4 A. Water Line Connections Ensure all fittings and end connections are free of debris. Faucet fittings (1) are 3/8" compression, with ends colored red for hot and blue for cold. Loop tubing (5) if it is too long. Note: Recommended tubing minimum bend diameter is 8". Secure metal nut (2) on faucet tube to supply valve connection (4) and hand tighten, then tighten one additional turn with wrench. DO NOT OVERTIGHTEN. Repeat for other tube.
PAGE 5
2 Custom Fit Connections Conexiones Especiales Spéciaux Branchement Incorrect Installation Instalación Incorrecta Installation Incorrecte Correct method Método Correcto Bonne méthode 2 3 1 4 Custom Fit Connections - Plastic Sleeve Installation Instructions 1. Identify desired length of tube (1). Leave 1" - 2" of extra length to allow for easier installation and cut tube. Ensure cut is straight and burr free. 2. Slide nut (2) and plastic sleeve (3) onto cut tube. Ensure sleeve is oriented as shown. 3.
PAGE 6
3 C. B. A. 2 2 1 1 3 Flush Supply Lines B. Then, while holding the outlet tube (1) over the C. Move faucet handle (2) to the off position, and A. Coloque un cubo o balde debajo del accesorio de B. Luego, mientras que sostiene el tubo de salida (1) C. Mueva la manija de la llave (2) a la posición Rincez les tuyaux d’alimentation A. Placez un seau sous le raccord de sortie (1) et B. Ensuite, tenez le tube de sortie (1) au-dessus C. Déplacez la manette (2) en position d’arrêt, A.
PAGE 7
4 A. 5 B. 2 6 3 4 2 3 1 4 1 1 5 Soap Dispenser Installation Note: Soap dispenser not included with all models. Hose Installation A. Insert hose end (1) through hose weight assembly (2). B. Push hose end (1) onto faucet outlet (3). Attach clip (4) over hose and outlet as shown. Pull down moderately to ensure connection has been made. B.
PAGE 8
6 B. A. 3 Function Wand Mango de 3 Funciones Poignée à 3 Fonctions 2 A 1 2 3 90º A 1 Check the operation of the 2 function sprayer by pushing the trigger (A) from aerator to spray. For models with a 3 function sprayer, check the operation by pushing the buttons to achieve the 3 different modes. A. Turn on water supplies (1) and faucet valve handle (2). Check all connections at arrows for leaks. Refer back to the appropriate installation instructions and retighten if necessary.
PAGE 9
7 1 2 Setting The Handle Limit Stop (Optional) because it limits the amount of hot water in the mix; however, this handle limit stop will not always prevent scalding because it does not compensate for incoming pressure or sudden water temperature changes. This faucet includes an integrated handle limit stop that has two positions. Position 1, to the left, allows full handle motion (the full range between “all cold” to “all hot”). The faucet is set in position 1 in the factory.
PAGE 10
Press Button Pulsar botón Pressez le bouton 4 5 6 3 7 1 2 Maintenance Replace valve cartridge (7). When reinstalling parts, make sure bonnet nut (6) is tightened securely with a wrench.* If faucet exhibits very low flow A. Remove and clean aerator (1) (Note: some models require wrench (2) to remove aerator.), or B. Unscrew hose from spray head and clean debris from screen (the screen is located just inside the spray (3). Note: Not all models have screens.
PAGE 11
Model / Modelo / Modèle 16971-DST RP50585▲ Set Screw & Button Tornillo de Presión y Botón Vis de calage et Bouton RP40650 Set Screw Tornillo de Presión Vis de calage RP80977 Wand Retainer & Replacement Kit Soporte para el mango y piezas de repuesto Trousse de rechange et pièce de retenue de douchette RP53435▲ Sprayer & Hose Assembly (Includes aerator) Rociador y Ensamble de la Manguera (Incluye el aireador) Douchette et Tuyau Souple (Inclut aérateur) RP60923 Friction Spacer Arandela de Fricción Rondelle
PAGE 12
Model / Modelo / Modèle 19949-DST RP80977 Wand Retainer & Replacement Kit Soporte para el mango y piezas de repuesto Trousse de rechange et pièce de retenue de douchette RP60978▲ Sprayer & Hose Assembly (Includes aerator) Rociador y Ensamble de la Manguera (Incluye el aireador) Douchette et Tuyau Souple (Inclut aérateur) RP50781▲ Dispenser Assembly Ensamble del Dispensador Distributeur RP50786▲ Button Botón Bouton RP40650 Set Screw Tornillo de Presión Vis de calage RP51502▲ Cap Casquete Embase RP60923
PAGE 13
Models / Modelos / Modèles 19922-DST RP80977 Wand Retainer & Replacement Kit Soporte para el mango y piezas de repuesto Trousse de rechange et pièce de retenue de douchette RP60977▲ Sprayer & Hose Assembly (Includes aerator) Rociador y Ensamble de la Manguera (Incluye el aireador) Douchette et Tuyau Souple (Inclut aérateur) RP50781▲ Dispenser Assembly Ensamble del Dispensador Distributeur RP53879▲ Button Botón Bouton RP47666 Set Screw Tornillo de Presión Vis de calage RP62875 Friction Spacer Arandela de
PAGE 14
Models / Modelos / Modèles 9178-DST, 9678-DST & 19978-DST RP51502▲ Cap Casquete Embase RP60923 Friction Spacer Arandela de Fricción Rondelle de frottement RP51503 Bonnet Bonete Chapeau RP50587 Valve Assembly Ensamble de la válvula Soupape RP50815 Aerator & Wrench Aereador y Llave Aérateur et Clé RP80523 Steel Weight Assembly Ensamble de la Pesa de Acero Masselotte en acier RP13938 O-Ring Anillo “O” Joint torique RP60911 Clip Presilla Agrafe RP63263 Adapters 3/8"-24 UNEF to 1/2"-20 UN & 3/8"-24 UNEF
PAGE 15
Models / Modelos / Modèles 9192-DST, 9992-DST & 19992-DST 19992-DST & 9192-DST 9992-DST RP37036 Set Screw Tornillo de Presión Vis de calage RP80977 Wand Retainer & Replacement Kit Soporte para el mango y piezas de repuesto Trousse de rechange et pièce de retenue de douchette RP62875 Friction Spacer Arandela de Fricción Rondelle de frottement RP60976▲ Sprayer & Hose Assembly (Includes aerator) Rociador y Ensamble de la Manguera (Incluye el aireador) Douchette et Tuyau Souple (Inclut aérateur) RP50781▲
PAGE 16
Models / Modelos / Modèles 9132-DST & 9932-DST 9132-DST 9932-DST RP80977 Wand Retainer & Replacement Kit Soporte para el mango y piezas de repuesto Trousse de rechange et pièce de retenue de douchette RP52140▲ Sprayer & Hose Assembly (Includes aerator) Rociador y Ensamble de la Manguera (Incluye el aireador) Douchette et Tuyau Souple (Inclut aérateur) RP62775▲ Lever Handle Manijas de Palanca Manette RP51502▲ Cap Casquete Embase RP60923 Friction Spacer Arandela de Fricción Rondelle de frottement RP515
PAGE 17
Notes / Notas / Notes 17 91888 Rev.
PAGE 18
Notes / Notas / Notes 18 91888 Rev.
PAGE 19
Notes / Notas / Notes 19 91888 Rev.
PAGE 20
Limited Warranty on Delta® Faucets Parts and Finish All parts (other than electronic parts and batteries) and finishes of this Delta® faucet are warranted to the original consumer purchaser to be free from defects in material and workmanship for as long as the original consumer purchaser owns the home in which the faucet was first installed or, for commercial users, for 5 years from the date of purchase.