Operating Guide

ManualsBrandsDelta ManualsBar FaucetsPivotal Single-Handle Bar Faucet with MagnaTite Docking in Black Stainless

PULLOUT AND PULL-DOWN KITCHEN SUITE

WITH RIBBON SPOUT

SET DE COCINA CON SURTIDOR ESTILIZADO

EXTRAÍBLE Y DESLIZABLE HACIA ABAJO

ROBINET À BEC RUBAN RÉTRACTABLE POUR

LA CUISINE

Model/Modelo/Modèle

PIVOTAL

™

Write purchased model number here.

Escriba aquí el número del modelo comprado.

Inscrivez le numéro de modèle ici.

06/21/2019 Rev. I

You may need/Usted puede necesitar/Articles dont vous pouvez avoir besoin:

Read all instructions prior to installation.

Lea todas las instrucciones antes de

hacer la instalación.

Veuillez lire toutes les instructions avant

l’installation.

91866

9693-DSTp

9693T-DSTp

To access additonal technical documents & product info, visit www.deltafaucet.com/p/Your-Model-Number-Here

(example: www.deltafaucet.com/p/9159T-DST)

Para acceder a documentos técnicos adicionales e información sobre el producto, visítenos en www.deltafaucet.

com/p/Your-Model-Number-Here (ejemplo: www.deltafaucet.com/p/9159T-DST)

Pour avoir accès à des documents techniques supplémentaires et à de l’information sur le produit, visitez www.delta-

faucet.com/p/Votre-numéro-de-modèle-ci (exemple : www.deltafaucet.com/p/9159T-DST)

www.deltafaucet.com

1-800-345-DELTA (3358)

customerservice@deltafaucet.com

3/32" (2.38 mm)

9193-DSTp

9193T-DSTp

4193-DSTp

9993-DSTp

9993T-DSTp

Summary of content (16 pages)

PAGE 1
91866 Model/Modelo/Modèle PULLOUT AND PULL-DOWN KITCHEN SUITE WITH RIBBON SPOUT SET DE COCINA CON SURTIDOR ESTILIZADO EXTRAÍBLE Y DESLIZABLE HACIA ABAJO ROBINET À BEC RUBAN RÉTRACTABLE POUR LA CUISINE PIVOTAL™ Write purchased model number here. Escriba aquí el número del modelo comprado. Inscrivez le numéro de modèle ici. 4193-DSTp 9193-DSTp 9193T-DSTp 9993-DSTp 9993T-DSTp 9693-DSTp 9693T-DSTp You may need/Usted puede necesitar/Articles dont vous pouvez avoir besoin: 3/32" (2.
PAGE 2
Touch2O® 9193T-DST 9693T-DST 9993T-DST 2 1 1 1 1 2 2 6 Slide base plate over hose assembly, ensure tab on base plate tab (1) is in the rear of the faucet for proper contact. Deslice la placa base sobre el conjunto de la manguera, asegúrese de que la lengüeta en la lengüeta de la placa base (1) esté en la parte posterior del grifo para un contacto apropiado.
PAGE 3
OPTIONAL ESCUTCHEON INSTALLATION INSTALACIÓN OPCIONAL DE UNA CHAPA INSTALLATION DE LA PLAQUE DE FINITION FACULTATIVE 1 2 9 3 2 6 3 4 9 8 4 5 5 For optional installations using the 10 1/2” escutcheon. Place spacer (9) in sink hole to insure no metal-to-metal contact with sink and faucet shank Place the escutcheon and gasket under faucet, hand tighten using escutcheon washers and nuts. Mount as shown above using the mounting bracket. Tighten mounting nut securely by hand, using wrench provided.
PAGE 4
6 7 8 2 1 Loop tubing if it is too long. Note: Recommended tubing minimum bend diameter is 8”. Tighten the nut with a wrench until secured, while using a second wrench to ensure you do not over tighten the check valves. Repeat for other supply stop. Turn on water, examine for leaks. Enlace el tubo si es demasiado largo. Nota: El diámetro mínimo recomendado de la curvatura para la tubería es de 8”.
PAGE 5
10 11 2 Side View Vista lateral Vue latérale 1 2 1 12 13 1 1 2 Wire must extend away from solenoid. Asegúrese que el alambre se extiende alejado del solenoide. Prenez soin de placer les fils à l’écart de l’électrovanne. 5 91866 Rev.
PAGE 6
14 “AA” Batteries Pilas “AA” Piles « AA » 1 IMPORTANT 2 “C” Batteries Pilas “C” Piles « C » Important: Place batteries in holder, secure cap as shown. For proper functionality DO NOT tie, twist or bunch the wires. Importante: Coloque las pilas en el soporte, fije el tapón se muestra. Para un funcionamiento adecuado NO amarre, tuerza o agrupe los alambres. Important : Placez les piles dans leur logement, fixez le couvercle comme le montre.
PAGE 7
1 2 4193-DST 9193-DST 9693-DST 9993-DST 1 1 3 2 1 Remove strip from gasket and place under base plate. Slide base plate over hose assembly, ensure tab on base plate tab (1) is in the rear of the faucet for proper contact. 2 Retire la tira de la junta y colóquela debajo de la placa base. Deslice la placa base sobre el conjunto de la manguera, asegúrese de que la lengüeta en la lengüeta de la placa base (1) esté en la parte posterior del grifo para un contacto apropiado.
PAGE 8
OPTIONAL ESCUTCHEON INSTALLATION INSTALACIÓN OPCIONAL DE UNA CHAPA INSTALLATION DE LA PLAQUE DE FINITION FACULTATIVE 1 2 3 2 6 3 4 8 4 5 5 Place the escutcheon and gasket under faucet, hand tighten using escutcheon washers and nuts. Mount as shown above using the mounting bracket. Position mounting nut by hand and then tighten with wrench provided. Set final position of faucet on deck. Then, using a Phillips screwdriver, securely tighten locking screws.
PAGE 9
7 8 Side View Vista lateral Vue latérale 2 9 1 CUSTOM FIT CONNECTIONS / CONEXIONES ESPECIALES / SPÉCIAUX TUYAUTERIE BRANCHEMENT Installer accepts the responsibility to cut supply tubing in a way that allows a leak-free joint to be created. Brizo is not responsible for tubing that is cut too short or cut in a way that will not allow for a leak-free joint. Must use RP50952 sleeves supplied with model and nuts included on supply lines. Tube cut must be straight.
PAGE 10
PLASTIC SLEEVE INSTALLATION / INSTALACIÓN DEL CASQUILLO PLÁSTICO / INSTALLATION DES MANCHONS EN PLASTIQUE 1 2 2 3 1 Do not install sleeve upside down. Ensure cut is straight. No instale la manga boca abajo. Asegúrese que el corte esté recto. N’installez pas le manchon à l’envers. Assurez-vous que la coupe est droite. Do not use RP51243 gasket (1) supplied with PEX tubing or brass ferrule (2) supplied with valve stops.
PAGE 11
LED Guide If LED is: Solid Blue - Solenoid valve is open, water temperature is less than 80°F (27°C). Solid Magenta - Solenoid valve is open, water temperature is between 80°F (27°C) and 110°F (43°C). Solid Red - Solenoid valve is open, water temperature is greater than 110°F (43°C). 3 3 red flashes before solenoid opens or closes - replace batteries. Guía del LED 1 Si el LED es: Azul sólido - La válvula solenoide está abierta, la temperatura del agua es menos de 27° C (27° C).
PAGE 12
Solenoid Troubleshooting Note: Normal operation of the faucet will turn off water flow if faucet is not touched for 4 minutes. 1. If your spout indicates three red flashes, replace the batteries. If the spout still indicates three red flashes, please replace the solenoid assembly**. (see manual bypass option below*) 2. If neither water or light indication are working properly, a. Check that all six batteries or inserted in the proper orientation. b. Replace your batteries c.
PAGE 13
91866 Rev.
PAGE 14
91866 Rev.
PAGE 15
91866 Rev.
PAGE 16
Limited Warranty on Delta® Faucets Parts and Finish All parts (other than electronic parts and batteries) and finishes of this Delta® faucet are warranted to the original consumer purchaser to be free from defects in material and workmanship for as long as the original consumer purchaser owns the home in which the faucet was first installed.