User's Manual
Table Of Contents
- Preface
- Table of Contents
- Chapter 1 Introduction
- 1.1 Receiving and Inspection
- 1.2 Appearances
- 1.3 Installation Steps
- 1.4 Storage
- Chapter 2 Installation and Wiring
- Chapter 3 Start Up
- Chapter 4 Digital Keypad Operation
- Chapter 5 Parameters
- Chapter 6 Fault Code Information
- Chapter 7 Troubleshooting
- 7.1 Over Current (OC)
- 7.2 Ground Fault
- 7.3 Over Voltage (OV)
- 7.4 Low Voltage (Lv)
- 7.5 Over Heat (OH)
- 7.6 Overload
- 7.7 Keypad Display is Abnormal
- 7.8 Phase Loss (PHL)
- 7.9 Motor cannot Run
- 7.10 Motor Speed cannot be Changed
- 7.11 Motor Stalls during Acceleration
- 7.12 The Motor does not Run as Expected
- 7.13 Electromagnetic/Induction Noise
- 7.14 Environmental Condition
- 7.15 Affecting Other Machines
- Chapter 8 Maintenance and Inspections
- Appendix A Specifications
- Appendix B Accessories
- Appendix C How to Select the Right AC Motor Drive
- Appendix D CE
Chapter 5 Parameters|VFD-S Series
5-56 Revision August 2006, SE08, SW V2.61
d20 Software protection enable (codE)
d21 Reserved
d22 CPU failure (cF3.1)
d23 CPU failure (cF3.2)
d24 CPU failure (cF3.3)
d25 CPU failure (cF3.4)
d26 CPU failure (cF3.5)
d27 CPU failure (cF3.6)
d28 CPU failure (cF3.7)
d29 Hardware protection failure (HPF.1)
d30 Hardware protection failure (HPF.2)
d31 Hardware protection failure (HPF.3)
d32 Communication time-out (CE10)
d33 Reserved
d34 Software error (SErr)
d35 Reserved
d36 PID error (Pld)
d37 Reserved
d38 Phase loss (PHL)
Pr.6-08 to 6-10 store records of the three most recent faults that had occurred. Use the reset
key to reset the drive when the fault no longer exits.