Hardware manual

AH500 Hardware Manual
5-59
 After the metallic shield and the foil are removed, the users
need to remove the plastic jackets of the power cables and
the plastic jackets of the signal cables properly.
 Insert the communication cable into the holes in the
connector.
Blue (CAN_L)
Shielded cable (CAN_SHLD)
Black (V-)
Red (V+)
White
(
CAN_H
)
 After the communication cable is inserted into the holes in
the connector, tighten the screws on the connector with a
slotted screwdriver.
5.9.1.3 Installing the DeviceNet Connector
 After the wiring is complete, users can insert the DeviceNet connector into the interface.
 Tighten the two screws on the DeviceNet connector.
Points for attention:
 After the communication cable is kept separate from the power cable, the electromagnetic interference is
reduced.
 Only after the both ends of the shielded cable are grounded can the shielded cable be brought into full
play.