Hardware manual

AH500 Quick Start

The configuration is as follows.

Power supply

CPU module

Rack 1 (eight-slot main backplane)

Rack 2 (eight-slot extension backplane)

ht racks at most

Motion control module

Network module

Motion control module

Power supply

Digital input module

Digital output module

Analog input module

Temperature

measurement module

Serial communication

module

Note: Owing to the consideration to the data transmission speed, the motion control modules and

the network modules (exclusive of the serial communication modules) have to be installed

with the CPU module on the same backplane. Otherwise, the system can not operate

properly.

The common framework of the AH500 system (for system integration):

The AH500 system can meet most system control requirements in the application field of the system

integration. Generally speaking, the system framework is related to the positions of the equipments.

A control panel is usually placed among the equipments which are concentrated to save the wiring

cost. However, there is usually more than one concentration point, and the distance between the

concentration points is over 100 meters. If it is necessary for users to place more than two control

panels, the RTU modules are required. The remote framework of the AH500 system not only fills the

remote requirement, but also is combined with the extension of the local I/O. Under most conditions,

a control panel instead of a backplane can be regarded as a remote I/O station. In addition, the

backplanes, the power supply modules, and other modules are compatible with one another. The

convenience of planning the system is increased, and the difficulty of choosing the products is also

decreased.

1-4