Specifications

System Options 85
Testing the Dial-Out Setup
2QFHý\RXýKDYHýVHWýWKHýSKRQHýQXPEH UV ñý0RGHPý0RG H ñýDQGý&DOOýúëýILHOGýWKHýZD\ý\RXýZDQWýWKHPñý
\RXªOOýSUR EDEO\ýZD QWýWRýNQRZýLIýLWýDOOýZRUNVýSURSHUO\ïý7KDWýLVýZKDWýWKHý'LDOðRXWý7HVWý6FUHHQýLVýIRUãý
7RýWHV Wý\RXUýGLDOðRX WýVHWXSñ ýFKDQJHýWKHý'LDOý7HVWýILHOGýIU RPý2))ýWRý67$57ïý,Iý\RXýSUHVVý$/$50ý
6,/(1&(ýZK LOHýWKHý'LDOý7HVWýILH OGýUHDGVý67$57ñýWKHýGLDOðRX WýWHVWýZLOOýEHJLQïý7KHýVHTXHQFH ýRIý
HYHQWVýZLOOýEHýLGHQW LFDOýWRýWKHýVHTXH QFHýWKDWýRFFXUVýZKHQýDý©UHDOªýGLDOðRXWýH YHQWýKDSSHQVïý)RUý
H[DPSOHñýLIýWKHý&DOOýúëýILHOGýLVýVHWýWRýúìý)$,/ñýWKHý836ýZLOOýRQO\ýFDOOýWKHýVHFRQGýSKRQHýQXPEHUýLIýLWý
FDQªWýFRQQHFWýWRýWKHýILUVWýQXPEHUñýRUýLIýWKHýILUVWýQXPEHUýLVýDýSDJHUï
:KLOHýWKHýGLDOðRXWýWHVWýLVýLQýSURJUHVVñýWKHý/DVWý$WWHPSWõVôýILHOGVýZLOOýUHIOHFWýWKHýSURJUHVVýõRUýODFNýRIý
SURJUHVVôýRIýWKHýGLDOðR XWïý1RWHýWKDWýWKHVHýILHOGVýDUHýDFWLYHýGXULQJýDQ\ýGLDOðRXWñýZKHWKHUýRUý
QRWýLWýLVýDýWHVWïý6LQFHýWKH\ýUHWDLQýWKHýUHVXOWýRIýWKHýODVWýGLDOðRXWýDWWHPSWñý\RXýFDQýFRQVXOWý
WKHPýWRýILQGýRXWýLIýDýSUHYLRXVýDWWHPSWýVXFFHHGHGýRUýIDLOHGïý7KHýILHOGVýZLOOýGLVSOD\ýRQHýRIýWKHý
IROORZLQJýPH VVDJHVã
,IýWKHýFXUUHQWýWHVWýLVýFDOOLQJýDQRW KHUýPRGHPñýWKHý/DVWý$WWHPSWõVôýILHOGýVK RXOGýHQGýZLWKý3$66('ïý
,IýWKHýFXUUHQWýWHVWýLVýFDOOLQJýDýSDJHUñýWKHý/DVWý$WWHPSWõVôýILHOGýVKRXOGýHQG ý DWý81.12:1ï
5.8.3 Setting the Data Rate
7KHý836ýKDVýDQý56ðëêëð&ýVHULDOýSRUWýZKLFKýLVýXVHGýWRýFRQQHFWýWRýHLWKHUýDQýLQWHUQDOýPRGHPñýLQWHUð
QDOý6103ýDGDSWHUñýRUýDQýH[WHUQDOýFXVWRPHUýLQWHUIDFHïý$VýVKLSSHGýIURPýWKHýIDFWRU\ñýWKHýVHULDOýSRUWý
LVýVHWýIRUýëéííýEDXGïý,Iý\RXýQHHGýWRýFKDQJHýWRýìëííýEDXGýõIRUýH[DPSOHñýWRýLQWHUIDFHýZLWKýDQýROGHUý
WHUPLQDOýZKLFKýGRHVQªWýVXSSRUWýëéííýEDXGôñý\RXýZLOOýQHHGýWRýPRYHýWKHýEDXGýUDWHýMXPSHUýDQGý
Table 11 Last Attempt(s) Messages
Messages Meaning
NONE
No dial-out has been attempted.
UNKNOWN
Displayed when UPS has called a pager. The UPS has no way to verify that the pager service
equipment has received the message, and certainly no way to verify that the radio transmission to
the pager was received or displayed. Although less common, this message will also be displayed if
the UPS lost control power at the moment it was transmitting data to another modem. This means
that the UPS is not sure the message got through.
NOT READY
The UPS cannot perform a dial-out at the moment because the modem is not ready. Usually this
means that a modem presence test was in progress at the moment a dial-out request occurred. Try
the dial-out test again in a minute or two. When an actual system event causes a dial-out, a NOT
READY state will not be a problem—the UPS will wait until the modem test is done and then restart
the dial-out.
DISABLED
Displayed in the #2 field if Call #2 is set to NEVER.
NO MODEM
The Modem Mode is set correctly, but the modem is either not installed, installed incorrectly, or
defective.
OUT MODE OFF
The Modem Mode is set to OFF or IN, both disable dial-outs.
NO DIAL TONE
The modem is responding, but reports no dial tone found. Check the phone line connection.
BUSY
The phone line is busy. The UPS will retry the number 20 times before giving up.
NO CARRIER
The UPS is calling a remote modem, but the remote modem is not responding with a carrier tone.
DIALING
The modem is dialing and/or waiting for a response.
SENDING
The modem is transmitting the message to either a remote modem or pager service equipment.
PASSED
The dial-out succeeded: the UPS connected with a remote modem and transmitted the message.
FAILED
The dial-out failed, UPS was unable to connect and has given up.
Dial Test: OFF
Last Attempt(s):
#1: NONE
#1: NONE