Installation Guide

ManualsBrandsDelta ManualsBathFoundations 38 in. L x 38 in. W Corner Shower Pan Base with Corner Drain in White

102311 Rev. A

B79912-3838-WH

B711912-3838-WH

CORNER SHOWER BASE

BASE PARA DUCHA DE ESQUINA

102311

Model / Modelo

Write purchased model number here. Retain

these instructions for future use.

Escriba aquí el número del modelo comprado.

Conserve estas instrucciones para usarlas en el futuro.

4/4/18

For product and installation questions, do not

return to the store. For additional help contact

customer service.

Para consultas sobre el producto y la

instalación, no regrese a la tienda. Para

obtener ayuda adicional, comuníquese con

el servicio al cliente.

www.deltafaucet.com

1‑800‑355‑2721

consumercare@deltafaucet.com

Summary of content (8 pages)

PAGE 1
Model / Modelo CORNER SHOWER BASE BASE PARA DUCHA DE ESQUINA Write purchased model number here. Retain these instructions for future use. Escriba aquí el número del modelo comprado. Conserve estas instrucciones para usarlas en el futuro. B79912-3838-WH B711912-3838-WH ? For product and installation questions, do not return to the store. For additional help contact customer service. Para consultas sobre el producto y la instalación, no regrese a la tienda.
PAGE 2
REQUIREMENTS FOR SUCCESSFUL INSTALLATION REQUISITOS PARA UNA INSTALACIÓN CORRECTA KNOWLEDGE BASE: Framing Plumbing These instructions include suggestions for rough construction and plumbing installation. Local building codes vary and could supersede those suggestions. If you are not confident in your ability to perform these tasks, contract out those tasks you need help with or use a professional installer. DO NOT use drywall screws to secure flanges to wall studs.
PAGE 3
ROUGHING-IN TUBERÍA INTERNA 38 1/4" min (97.16 cm) • Rough plumbing must be installed before base installation. • Minimum stud pocket sizes are shown below. • Drain cutout 5” diameter max. Right side plumbing rough-in shown. • For masonry construction, floor and walls must be framed to accommodate plumbing and installation. A IMPORTANT: IF INSTALLING MATCHING ENCLOSURE, refer to Enclosure Installation Manual for specific lumber sizes and placement.
PAGE 4
3 AVISO NOTICE NO corte el RIEL SUPERIOR del mismo largo que el RIEL INFERIOR. DO NOT cut the TOP TRACK the same length as the BOTTOM TRACK. 1 NOTICE For optimal water retention, water dam installation and/or proper caulking of this enclosure is necessary. Follow all steps as per sealant manufacturer’s instructions. AVISO Para una retención óptima del agua, la instalación de la lengüeta para la retención del agua y/o el calafateo de este recinto es necesario.
PAGE 5
6 A 5” (12.7 cm) A. Flat and Level Floor Aplane y nivele el piso B. Uneven Floor Piso desnivelado 1 1/2” (1.3 cm) 2 A. If subfloor is flat and level, and mortar was not used, apply adhesive A on floor using 1/4" square-notched trowel, staying within pencil line (1). Proceed to step 7. Ensure that the waste pipe is properly located to align with the drain assembly (not included). Subfloor maximum diameter opening should be 5". The drain pipe should be 1/2” above the subfloor. B.
PAGE 6
7 8 Shim 1 It is recommended not to stand in base while securing to wall. Set base in corner and press it into adhesive. Finish installing drain per manufacturer's instructions. 2 Secure flanges to all studs with 1 1/2” panhead or roundhead screws through previously drilled holes. 3 NOTE: Gaps between flanges and studs must be less than 1/8”. Insert shims to fill gaps if needed. Termine la instalación del desagüe de acuerdo con las instrucciones del fabricante.
PAGE 7
CARE AND CLEANING 9 We recommend that you clean your acrylic bathing product with mild detergents. Use a terry cloth towel, soft cloth or sponge. Avoid using abrasive scrubbing pads, steel wool or sponges. After cleaning, rinse thoroughly with water. NOTICE When using drain cleaner or clog remover, rinse thoroughly with water. NOTICE Certain chemicals and cleaners may deteriorate the product surface, causing cracks and potentially, property damage.
PAGE 8
Limited Warranty on Bathing Products What You Must Do To Obtain Warranty Service or Replacement Parts. A warranty claim may be made and replacement parts may be obtained by calling 1 800 355 2721 or by writing to: In the United States and Mexico: In Canada: Delta Faucet Company Masco Canada Limited, Plumbing Group Product Service Technical Service Centre 55 E. 111th Street 350 South Edgeware Road Indianapolis, IN 46280 St. Thomas, Ontario, Canada N5P 4L1 customerservice@deltafaucet.