User's Manual

Chapter 3 Creating and Editing Screens
and the Screen Cycle Macro is set as
the user’s screen will look like the figure shown below.
 CIRCLE (Draw an Ellipse)
Equation
RECTANGLE (Var1)
Explanation
This command is used to draw an ellipse on the screen.
Var1 is the X-coordinate of the center of the ellipse
Var1+1 is the Y-coordinate of the center of the ellipse
Var1+2 is the length of the ellipse
Var1+3 is the width of the ellipese
Var1+4 is the color of the ellipse
Remark
 Var1 can be internal memory only.
Example
When the Screen Open Macro command is set as
and the Screen Cycle Macro is set as
3-368 Revision May, 2010