User's Manual

Chapter 3 Creating and Editing Screens
 Code – 107 There is RET in Macro
This error message means that there is RET command in Macro. The RET command
should be used for sub-macro to return program. But in Macro, it should use END not
RET.
HMI Macro Error Messages
The users can read error messages by macro files. Once there is an error and the users
execute a correct command before reading error messages, the error message will be
overwritten. When executing each macro, each Macro error message will not be influenced
by other macros.
 Code – 10 GOTO Error
This message means that there is a GOTO error in the macro.
 Code – 11 Stack Overflow
This message means that the stack in the macro is full. This may be caused by using
too many sub-macros or executing different macros at the same time. This message
appears to help avoid insufficient memory.
 Code – 12 Empty Sub-macro
This is a CALL sub-macro error. The sub-macro that is called should not be an empty
sub-macro. This message is to avoid unexpected errors.
 Code – 13 Data Read Error
This is a data read error. Sometimes this may be caused by a memory data error, but
most of the time it is an external controller data read error.
 Code – 14 Data Write Error
This is a data write error. Sometimes this may be caused by a memory data error, but
most of the time it is an external controller data write error.
 Code – 15 Divisor is 0
This error message means that the devisor is 0 when performing a division operation.
Revision May, 2010 3-377