User's Manual

Delta Temperature Controller User Manual

Display Explanations

PV SV Status of the temperature controller

Message displayed when DTA has not yet been connected

to a sensor.

Press for

more than 3

seconds to enter

initial setting

mode

Select the sensor connected. Default = PT100

Temperature unit. Default = °C

Upper limit of temperature range

Lower limit of temperature range

The control modes include: PID, ON/OFF, MANUAL.

Default = PID. Select “ON/OFF” here.

Select heating or cooling mode. Default = heating

Set up Alarm mode 1. Default = alarm output disabled

Set up Alarm mode 2. Default = alarm output disabled

ON/OFF of communication write-in. Default = OFF

Communication address

Communication speed

Data length (in bits)

Parity bit

Stop bit