Instruction manual

ASSEMBLING FENCE

CARRIAGE ASSEMBLY

1. Remove the two M10x1.5x30mm hex socket head

screws (A) Fig. 11, and 10mm flat washers from the back

of the jointer base at location (C).

2. Align the two holes (B) Fig. 11, in the fence carriage

assembly, with the two tapped holes (C) in the back of

the jointer base. Insert the M10x1.5x30mm hex socket

head screw with a 10mm flat washer, through the hole in

the fence carriage assembly and thread the screw into

the tapped hole in the back of the Jointer base. Repeat

this process for the remaining hole in the fence carriage

assembly and the tapped hole in the back of the Jointer

base. NOTE: THE TOP SURFACE (D) FIG. 12, OF THE

FENCE CARRIAGE ASSEMBLY MUST BE LEVEL

WITH THE TOP SURFACE (E) OF THE OUTFEED

TABLE. Once the fence carriage assembly is level with

the outfeed table, tighten the two screws (A) Fig. 11

securely.

Fig. 11

Fig. 12

ASSEMBLING FENCE

1. Remove the two M8x1.25x30mm hex socket head

screws (F) Fig. 12.

2. Align the two holes, one of which is shown at (G) Fig.

13, in the fence with the two holes (H) Fig. 12, in the

fence carriage assembly. Insert the screw through the

hole in the fence and thread the screw into the tapped

hole in the fence carriage assembly and tighten securely.

Repeat this process for the remaining hole in the fence

and fence carriage assembly.

3. Thread the fence tilting handle (A) Fig. 14, into the

tapped hole (B) in the fence.

Fig. 13

Fig. 14