Instruction manual

ASSEMBLING

CUTTERHEAD GUARD

Loosen set screw (A) Fig. 16. Insert post (B) of the

cutterhead guard into hole in infeed table and tighten set

screw (A) against the flat on post (B).

Make certain that guard operates freely

and does not bind or hang-up. Always check guard

operation before turning on jointer.

Fig. 16

ASSEMBLING

RABBETING LEDGE

1. Remove the two M6x1x20mm socket head screws

2. Align the two holes (A) Fig. 15, in the rabbeting

ledge, with the two holes (B) in the front of the Jointer.

Insert the screw through the hole (A) in the rabbeting

ledge and thread the screw into the tapped hole (B) in

the front of the Jointer. Make sure the rabbeting ledge is

level with the infeed table. Tighten screw (C) securely.

Repeat this process for the remaining hole in the

rabbeting ledge and the front of the Jointer.

Fig. 15

OPERATING CONTROLS AND ADJUSTMENTS

STARTING AND STOPPING

JOINTER

To turn the machine “ON”, push the green start button

(A) Fig. 17. To turn the machine “OFF”, push the red

stop button (B).

LOCKING SWITCH IN THE

“OFF” POSITION

IMPORTANT: When the tool is not in use, the switch

should be locked in the “OFF” position to prevent

unauthorized use, using a padlock (C) Fig. 18 with a

3/16" diameter shackle.

Fig. 17

Fig. 18