Instruction manual

Fig. 34

2. Using a square (D) Fig. 34, check to see if the fence

is at 90 degrees to the table, as shown.

3. If the fence is not at 90 degrees to the table, loosen

set screw (E) in the index collar (B), Fig. 33, and loosen

the fence locking handle (C). Move the fence until you

are certain it is at 90 degrees to the table and tighten

locking handle (C) and set screw (E).

Fig. 35

4. Tilt the fence inward as far as possible and using a

combination square (F) Fig. 35, check to see if the fence

is tilted inward 45 degrees, as shown. If an adjustment

is necessary, loosen locknut (H) Fig. 36, and turn

adjusting screw (J) in or out until the fence is 45 degrees

to the table, and tighten locknut (H). Then tighten lock

handle (C).

5. Tilt the fence outward as far as possible and using a

combination square (K) Fig. 37, check to see if the fence

is tilted outward 45 degrees, as shown. If an adjustment

is necessary, loosen lock handle (C) Fig. 37. Loosen

locknut (L) and turn adjusting screw (M) until the fence is

at 45 degrees to the table. Then tighten locknut (L) and

lock handle (C).

Fig. 36

Fig. 37