Instruction manual

8
ASSEMBLY
JOINTER TO STAND
If you purchased your jointer complete with stand and
electricals, factory mounted and wired, the stand is
shipped with the motor and switch completely wired and
assembled to the stand, as shown in Fig. 4.
The outfeed end of the jointer Fig. 4A must be pointing
toward the end of the stand with dust chute (A) Fig. 4.
Fig. 4
Fig. 5
2. Line up the eight holes (B) Fig. 5, on the top of the
stand with the eight threaded holes on the bottom of the
jointer base and fasten the jointer to the stand using the
eight M8x1.25x25mm socket head cap screws and
M8.1 lockwashers supplied.
THE JOINTER IS EXTREMELY HEAVY.
HAVE TWO OR MORE PEOPLE LIFT THE MACHINE
ONTO THE STAND.
A
C
D
E
B
B
Fig. 4A
1. Remove three screws (C) Fig. 4, and loosen three
screws (D). Then remove back panel (E) from stand by
lifting upward.
Outfeed Table
Infeed Table