Owner Manual

ManualsBrandsDelta ManualsBathroom Remodel & Bathroom FixturesClassic Widespread Bathroom Faucet with Drain Assembly

TWO HANDLE WIDESPREAD

LAVATORY FAUCETS

LLAVES DE LAVAMANOS

EXTENDIDAS DE DOS MANIJAS

ROBINETS À ENTRAXE LONG À

DEUX POIGNÉES POUR LAVABO

Models/Modelos/Modèles

3530LF & 3544LF-WFMPU

Classic Series/Series/Seria

Para instalación fácil de su llave

Delta usted necesitará:

• LEER TODAS las instrucciones completamente

antes de empezar.

• LEER TODOS los avisos, cuidados, e

información de mantenimiento.

• Comprar las conexiones correctas para el

suministro de agua.

For easy installation of your Delta

faucet you will need:

• To READ ALL the instructions completely

before beginning.

• To READ ALL warnings, care, and maintenance

information.

• To purchase the correct water supply hook-up.

Write purchased model number here.

Escriba aquí el número del modelo comprado.

Inscrivez le numéro de modèle ici.

You may need/Usted puede necesitar/

Articles dont vous pouvez avoir besoin:

SILICONE

Icons

SILICONE

Icons

Pour installer votre robinet Delta

facilement, vous devez:

• LIRE TOUTES les instructions avant

de débuter;

• LIRE TOUS les avertissements ainsi que toutes

les instructions de nettoyage et d’entretien;

• Acheter le bon nécessaire de raccordement.

3/32” (2.38mm)

07/21/2020 Rev. I

SILICONE

Icons

SILICONE

Icons

SILICONE

53916

www.deltafaucet.com

Summary of content (8 pages)

PAGE 1
53916 TWO HANDLE WIDESPREAD LAVATORY FAUCETS LLAVES DE LAVAMANOS EXTENDIDAS DE DOS MANIJAS ROBINETS À ENTRAXE LONG À DEUX POIGNÉES POUR LAVABO Models/Modelos/Modèles 3530LF & 3544LF-WFMPU Classic Series/Series/Seria Write purchased model number here. Escriba aquí el número del modelo comprado. Inscrivez le numéro de modèle ici. TEF LO N TEF LO N SI LI CO NE SI LI CO NE You may need/Usted puede necesitar/ Articles dont vous pouvez avoir besoin: 3/32” (2.
PAGE 2
Limited Warranty on Delta® Faucets Parts and Finish. All parts (other than electronic parts and batteries) and finishes of Delta® faucets purchased from authorized Delta sellers are warranted to the original consumer purchaser to be free from defects in material and workmanship for as long as the original consumer purchaser owns the home in which the faucet was first installed.
PAGE 3
1 B. A. 1 2 5 1 4 2 3 3 C. E. D. 1 2 3 2 1 3 4 A. Properly align base (1) on end valves. Slide hot (2) and cold (3) end valves with D. Install the spout (1) and gasket (2). Secure with washer (3) and nut B. Pass washer (1) then nut (2) over copper tube (3) and screw on end valve. E. and end valve nipples (3). Pull down moderately to ensure each gaskets (4) through sink. NOTE: Hot side end valve is labeled (5)! Secure with wrench. Repeat steps B and C for remaining end valve.
PAGE 4
A. C. B. E. D. 1 IC O S IL NE 2 1 2 3 2 3 2 1 1 1 G. F. 4 2 2 H. 5 4 3 2 1 5 1 2 3 2 1 6 Step 3b Metal Pop-Up A. Remove stopper (1) and flange (2). D. Apply silicone to underside of flange (1). Insert B. Screw nut (1) all the way down. Push washer E. Pivot (1) must face faucet. Pull assembly (2) C. Remove tailpiece (1) from body (2), add F. Tighten nut/washer/gasket (1), clean off excess (2) and gasket (3) down. plumber tape (3), replace tailpiece. body (2) into sink.
PAGE 5
B. C. NE I CO 1 SIL 3 A. 5 3 3 5 2 2 4 4 D. F. E. 12 1 11 8 3 8 7 2 6 9 10 Pop-Ups with Metal Flange and Plastic Tail Piece A. Remove stopper (1), brass nut & washer (2), black gasket (3) and tail piece (4). B. Apply silicone to underside of flange (5). Insert flange into sink. D. With pivot (6) facing toward faucet, pull pop-up straight down into drain hole and secure gasket (3), brass nut and washer (2). DO NOT TURN POP-UP WHILE TIGHTENING BRASS NUT OR SEALANT MAY NOT SEAL DRAIN.
PAGE 6
5 4 2 3 1 2 1 1/2" (13 mm) IPS 3 2 1 1 2 3 Make Connections to water lines: Choose hook-ups for 1/2" I.P.S. connections: (1) Ball nose riser (3/8" O.D. copper tubing), or (2) 1/2" I.P.S. faucet connector Use the enclosed coupling nuts (3) with the ball nose risers (1). Use two wrenches when tightening. Do not overtighten. Haga las conexiones a la líneas de agua: Escoja las conexions IPS de 1/2": (1) Conexión Bola-nariz (Tubería de cobre de 3/8" D.E.), o (2) Conector de llave I.P.S.
PAGE 7
3530 & 3544 Series/Series/Seria RP6060, RP6060SB Bonnet Nuts Bonetes/Capuchones Chapeaux Filetés RP54971p Lift Rod & Finial Barra de Alzar y Pomo Tige de Manoeuvre et Grain de la Tirette RP24097 1/4 Turn Stop Tope a un 1/4 de Giración Butée 1/4 de Tour RP24096 Stem Unit Assembly–Brass Stem–SS Plate Ensamble de la Unidad del Vástago–Vástago Bronce– Placa de Acero Inoxidable Obturateurs–Obturateur Laiton–Plaque en Acier Inoxydable RP1740 Stem Unit Assembly Ensamble de la Unidad del Vástago Obturateurs RP1
PAGE 8
RP26533p Metal Pop-Up Assembly Less Lift Rod RP26533p Ensamble de Metal del Desagüe Automático Sin la Barra de Alzar Renvoi Mécanique en Métal RP26533p Sans la Tige de Manoeuvre RP5648p Stopper Tapón Bonde RP5648 Stopper Tapón Bonde RP12516 Strap & Screw Barra Chata y Tornillo Feuillard et Vis RP23060p Flange Reborde Collerette RP38958 Pop-Up Assembly Less Lift Rod RP38958 Ensamble del Desagüe Automático Sin la Barra Para Alzarlo RP38958 Renvoi Mécanique Sans la Tirette Flange Brida Collerette RP6142