Manual

DeviceNet Network Scanner DVPDNET-SL

9 Setup of Extended Baud Rate

9.1 Setup of Extended Baud Rate (as master mode)

1) Connect the device to the Devicenet network according to the following figure. PC accesses PLC MPU via

RS232 or RS485.

DVP28SV

DVPDNET-SL

DeviceNet Builder

2) Open DeviceNet Builder software and select “Setup” => “Communication Setting” => “System Channel”. And

then the following dialog box appears.

3) Set up the communication parameters in the PC and DVP-SV, e.g. the communication port, address, baud

rate and communication format. Click on “OK” after configuration is finished.

Item Function Default

COM Port

COM port on the PC to be used to communicate

with DVP-SV

COM1

Address

Communication address of DVP-SV

Baud rate

Communication speed between the PC and

DVP-SV

9,600 (bps)

Data Bits 7

Parity Even Parity

Stop Bit

Communication protocol between the PC and

DVP-SV

Mode

Communication mode between the PC and

DVP-SV

ASCII

4) Select “Network” => "Online” and the following “Select Communication Channel” dialog box will appear. Click

on “OK”.

DVP-PLC Operation Manual