Instruction manual

CHAPTER 6: SETPOINTS CONFIGURATION SETPOINTS
MM300 MOTOR MANAGEMENT SYSTEM – INSTRUCTION MANUAL 6–21
Set Time
Set to program current time.
Time Offset from UTC
Range: -24 to +24 step 0.25
Default: 0.00
Enter the time in hours that your zone is off from Universal Time.
Daylight Savings
Range: Disabled/Enabled
Default: Disabled
Set to enable automatic time change based on the DS time setpoints.
Orange LED Intensity
Range: 1 to 6
Default: 1
Selects brightness level (1 to 6) for Control Panel LEDs.
Green LED Intensity
Range: 1 to 6
Default: 1
Selects brightness level (1 to 6) for Control Panel LEDs.
Red LED Intensity
Range: 1 to 6
Default: 1
Selects brightness level (1 to 6) for Control Panel LEDs.
User 1 LED Assignment, User 2 LED Assignment, User 3 LED Assignment
Range: any FlexLogic™ operand
Default: Not Set
Set to program the GCP/BCP user LEDs to follow an internal element.
USER 1 LED Color
Range: None, Red, Green, Orange
Default: Red
Selects the color of the USER 1 LED.
USER 2 LED Color
Range: None, Red, Green, Orange
Default: Red
Selects the color of the USER 2 LED.
USER 3 LED Color
Range: None, Red, Green, Orange
Default: Red
Selects the color of the USER 3 LED.
Screen Saver Feature
Range: Enabled, Disabled
Default: Enabled
Screen saver will become active after five (5) minutes of LCD inactivity. The LCD will
switch off after this time interval. Timing is fixed.