Instruction manual

ManualsBrandsDelta ManualsCordless SawMS350

Fig. 35

Fig. 36

Fig. 37

Fig. 38

CUTTING

CROWN MOULDING

One of the many features of your saw is the ease of

cutting crown moulding.The following is an example of

cutting both inside and outside corners on 52/38 degree

wall angle crown moulding. NOTE: When cutting 45 degree

wall angle crown moulding, the following procedure for

inside and outside corners is the same with the

exception that the bevel position will always be at 30

degrees and the miter position will be 35.25 degrees to

the right or left.

1. Move the table to the 31.62 degree right miter

position and lock the table in position. NOTE: A triangle

indicator and positive stop are are provided on the miter

scale to help find this angle quickly.

2. Tilt the saw blade to the 33.85 degree left bevel

position and tighten bevel lock handle. NOTE: A triangle

indicator is provided on the bevel scale to find this angle

quickly.

3. Place the crown moulding on the table with the

CEILING EDGE (AA) Fig. 35 of the moulding against the

fence, and make the cut (Fig. 35). NOTE: The piece of

crown moulding used for the outside corner will always

be on the right hand side of the blade (A) Fig. 35. The

piece of crown moulding used for the inside corner will

always be on the left hand side of the blade (B) Fig. 35.

4. To make the matching halves of the inside and

outside corners, rotate the table to the 31.62 degree left

miter position and tighten table lock handle. NOTE: A

triangle indicator and a positive stop are provided on the

miter scale to find this angle quickly.

5. Place the crown moulding on the table with the

WALL EDGE (BB) Fig. 36 of the crown moulding against

the fence and make the cut. Again, the piece of crown

moulding used for the outside corner will always be on

the right side of the blade (C) Fig. 36. The piece of crown

moulding used for the inside corner will always be on the

left side of the blade (D) Fig. 36.

6. Fig. 37 illustrates the two outside corner pieces - (A)

being the piece cut at (A) Fig. 35, and (C) being the piece

cut at (C) Fig. 36.

7. Fig. 38 illustrates the two inside corner pieces - (B)

being the piece cut at (B) Fig. 35, and (D) being the piece

cut at (D) Fig. 36.