Instruction manual

Fig. 41

Fig. 42

MAINTENANCE

CHANGING THE BLADE

WARNING: USE ONLY CROSS-CUTTING SAW

BLADES. WHEN USING CARBIDE TIPPED BLADES,

DO NOT USE BLADES WITH DEEP GULLETS AS THEY

CAN DEFLECT AND CONTACT THE GUARD. USE ONLY

″″

DIAMETER SAW BLADES WHICH ARE RATED FOR

5200 RPM OR HIGHER AND HAVE 5/8

″″

DIAMETER

ARBOR HOLES.

1. DISCONNECT MACHINE FROM POWER SOURCE.

2. Remove screw (A) Fig. 39 and rotate cover (B) to the

rear (Fig. 40).

3. To remove the saw blade, insert hex wrench (C)

Fig. 41 into the hex hole located on the rear end of the

motor shaft to keep the shaft from turning.

4. Use a wrench (D) Fig. 42 to loosen arbor screw (E)

by turning it clockwise.

5. Remove arbor screw (E) Fig. 42, outside blade

flange (F), and saw blade (G) from saw arbor.

6. Attach new saw blade MAKING CERTAIN TEETH

OF SAW BLADE ARE POINTING DOWN AT THE

FRONT. Attach outside blade flange (F) Fig. 42, and

arbor screw (E) by turning it counterclockwise using

wrench (D) Fig. 42. At the same time, use hex wrench (C)

Fig. 41 to keep the arbor from turning.

7. Replace screw and cover that was rotated to the

rear in STEP 2.

WARNING: REMOVE WRENCHES (C) FIG. 41 AND

(D) FIG. 42 BEFORE STARTING MACHINE.

Fig. 39

Fig. 40