Instruction manual

ROTATING TABLE FOR MITER CUTTING

Your miter saw will cut any angle from a straight 90 degree cut

to 47 degrees right and left. Loosen lock handle (A) Fig. 13 one

or two turns, depress index lever (B), and move the table to the

desired angle. TIGHTEN LOCK HANDLE (A).

The miter saw is equipped with positive stops at the 0, 22.5,

31.62, and 45 degree right and left positions. Loosen lock

handle (A) Fig. 13, and move the table until the bottom of the

index lever (B) engages into one of the positive stops, three of

which are shown at (C). TIGHTEN LOCK HANDLE (A).To

disengage the positive stop, loosen lock handle and depress

index lever (B).

In addition, a triangle indicator and positive stop are provided on

the miter scale at the 31.62 degrees right and left miter positions

for cutting crown moulding. (Refer to the “CUTTING CROWN MOULDING” section of this manual).

Fig. 14

POINTER AND SCALE

An indicator (E) Fig. 14 shows the actual angle of cut.

Each line on the scale (F) represents 1/2 degree. When

the indicator is moved from one line to the next on the

scale, the angle of cut is changed by 1/2 degree.

ADJUSTING POINTER

If it becomes necessary to adjust the indicator (E) Fig.

14, loosen screws (G), adjust the indicator (E), and

tighten screws.

Fig. 13

IMPORTANT: ALWAYS TIGHTEN LOCK HANDLE (A) FIG. 13 BEFORE CUTTING.

Fig. 15

Fig. 16

TOOL STORAGE

Convenient storage spaces for both the supplied blade

removal wrench and the supplied hex wrench are

located on the machine.

The hex wrench storage (A) Fig. 15 is located immedi-

ately behind the sliding fence (B).

The blade removal wrench storage (C) Fig. 16 is located

behind the opposite fence (D).