Specifications

PROFIBUS DP Slave Communicaion Module RTU-PD01
DVP-PLC Operation Manual
13
Definitions of configuration items:
Parameter Value Definition
Location 0 ~ 7
The location of DVP04DA-S at the right side of RTU-PD01. The
location of the first special I/O module at the right side of RTU-PD01 is
0, the second is 1 and so forth. This rule is only applicable on special
I/O modules.
0V ~ 10V
The output channel on DVP04DA-S is set to mode 0: Voltage output
mode. Output range: 0V ~ +10V
2V ~ 10V
The output channel on DVP04DA-S is set to mode 1: Voltage output
mode. Output range: 2V ~ 10V
4mA ~ 20mA
The output channel on DVP04DA-S is set to mode 2: Current output
mode. Output range: 4mA ~ 20mA
CH1 output mode
CH2 output mode
CH3 output mode
CH4 output mode
0mA ~ 20mA
The output channel on DVP04DA-S is set to mode 3: Current output
mode. Output range: 0mA ~ 20mA
z Configuration method for DVP06XA-S
Refer to the figure below for the relevant parameters to configure DVP06XA-S.