User Manual

10 Wiring and Installation
10.3.7. RMC150 Analog Input Wiring
This topic covers the wiring of the analog inputs on the RMC150 Analog (A), Analog (G),
Analog (H), and Universal I/O modules. For the Control Output (Drive) wiring, see the RMC150
Control Output (Drive) Wiring topic.
Use shielded twisted pairs for all connections to inputs and outputs. Route the transducer
wiring separate from other wiring. You must provide the power supplies needed by your
transducers. See Wiring Guidelines
for general wiring information.
Wire clamp screws must be tightened to max 4.5 lb-in (0.51 Nm).
Note:
The example schematics do not include transducer pin numbers, color codes, or power supply
requirements, since these vary between different transducers. To determine your power
deltamotion.com 1153