User Manual

RMC70/150 and RMCTools User Manual
To minimize electrical interference:
• -In and Cmn must be connected. This connected should be made as close to the
transducer as possible.
• Use individually shielded twisted-pair wire.
• Typically, the cable shield should be connected to earth on one end only.
Current 4-20mA, 2-Wire
Note:
The Analog (G) Module does not support current feedback.
Notes:
• The Res and -In pins are internally connected via a 250 Ohm resistor.
• To minimize electrical interference, use individually shielded twisted-pair wire.
1156 Delta Computer Systems, Inc.