User Manual

8 Command Reference
DINT
External:
REAL
Description
This command deletes curves with IDs in the range of Curve ID to Curve ID + Curve
Count -1 will de deleted. Only curves that exist are deleted. An entry will be logged in
the Event Log for each curve that is deleted. Attempting to delete non-existent curves will
not cause an error.
After a curve is deleted, it cannot be used anymore and the space it occupied in the curve
store is freed up. If a curve is deleted while it is being followed, it will not be interrupted
and will continue to work properly, but cannot be used again after the curve completes.
8.4.7.8. Command: Curve Delete Except (84)
Firmware Requirement:
2.40 or newer
Hardware Limitations:
RMC75S: versions 2.1D or newer only
RMC75P: versions 2.1E or newer only
RMC75E: No limitations
RMC150E: No limitations
See the Commands Overview
topic for basic command information and how to issue
commands from PLCs, HMIs, etc.
Command Parameters
#
Parameter Description
Data Type
Range
1
Curve ID
Internal:
DINT
External:
REAL
0-50000
2
Curve Count
Internal:
DINT
External:
REAL
>0
Description
This command deletes all the curves except for curves with IDs in the range of Curve ID
to Curve ID + Curve Count -1. An entry will be logged in the Event Log for each curve
that is deleted.
After a curve is deleted, it cannot be used anymore and the space it occupied in the curve
store is freed up. If a curve is deleted while it is being followed, it will not be interrupted
and will continue to work properly, but cannot be used again after the curve completes.
8.4.7.9. Command: Curve Delete All (85)
Firmware Requirement:
2.40 or newer
Hardware Limitations:
RMC75S: versions 2.1D or newer only
deltamotion.com 769