Operating Guide

19
ADJUSTMENTS
DEPTH STOP ADJUSTMENT
FENCE EXTENSION ADJUSTMENT
This miter saw is equipped with an adjustable depth stop
for making through cuts and non-through cuts.
Refer to Figure 24 depth stop at a specific cut depth:
use a Phillips head screwdriver to loosen screw (C) and
then rotate the stop bracket (B) counterclockwise into
the down position. Make sure to re-tighten screw (C).
The cut depth can now be adjusted by turning the depth
adjustment screw (A).
Refer to figure 24 and follow these instructions
in order to make a through cut: use a Phillips head
screwdriver to loosen screw (C) and then rotate the stop
bracket (B) clockwise into the up position. Make sure to
re-tighten screw (C).
Always check to make sure screw (C) is
tightened before making a cut. Failure to
do so may result in injury.
This saw is equipped with an adjustable extension fence.
To extend or retract the fence refer to Figure 25 and
follow these instructions: Loosen the wing nut (E) by
rotating counterclockwise and the slide the fence (D) into
the desired position. Make sure to re-righten wing nut (E)
by rotating clockwise.
FIGURE 24
FIGURE 25
LASER ADJUSTMENT
This saw is equipped with an adjustable laser which
projects a red line onto the work piece surface, see
Figure 26. Refer to the “Using Your Laser Guide” section
on page 13 for more information on how to operate laser.
This section will instruct you how to adjust the laser
alignment for more accurate cuts.
FIGURE 26
Always check to make sure wing nut (E)
is tightened before making a cut. Failure
to do so may result in injury.
• Avoid direct eye exposure to laser beam or reflection.
Intense or prolonged exposure to laser radiation
could permanently damage your eyes. Do not project
or reflect the laser into anyone’s eyes, including your
own.
• Caution -- use of controls or adjustments or
performance of procedures other than those
specified herein may results in hazardous radiation
exposure.
• Use or modification of the laser guide for anything
other than its designed purpose may result in
hazardous radiation exposure.
A
SERRER
DESSERRER
D
E
B
C