Operating Guide

20 21

LASER PARALLEL ADJUSTMENT

If you notice the laser line is not perfectly parallel with the

saw blade refer to Figure 27 and follow these instructions:

using a Phillips head screwdriver turn screw (A) until the

laser line is parallel with the saw blade.

LASER VERTICAL ANGLE

ADJUSTMENT

If you notice the laser line does not remain parallel to the

blade as the saw head is lowered to make a cut refer to

Figure 28 and follow these instructions: using a Phillips head

screwdriver turn the screw (B) to adjust the vertical angle of

the laser.

LASER OFFSET ADJUSTMENT

If you notice the laser line is offset from the actual cut line

refer to Figure 29 and follow these instructions: using a

Phillips head screwdriver turn the screw (C) to adjust the

offset.

FIGURE 29

FIGURE 28

FIGURE 27

ADJUSTMENTS