Operating Guide

10
GENERAL PARTS KNOWLEDGE
ASSEMBLY
STAND ASSEMBLY
Assemble stand part 2 (I) through stand part 1 (H) that
has cross support as shown in (Fig. 1). Secure stand
assembly with M8 x 65mm hex socket head screw (d),
M8 spacer (c), M8 washer (b), and M8 lock nut (e). (Fig.
1)
NOTE: M8 spacer (c) is between stand part (H) and (I).
(Fig. 2) for correct stand parts setup.
The part and hardware names and letters correspond to those shown in General Parts Knowledge, Shipping Contents,
and the Hardware Contents.
BEVEL SCALE
BLADE WRENCHES
STAND
ON/OFF
SWITCH
BEVEL
LOCK
HEIGHT
ADJUSTMENT
WHEEL
FENCE RAIL
SCALE
MITER GAUGE
BLADE GUARD
TABLE
RIP FENCE
PUSH STICK
ANTI-KICKBACK PAWLS
THROAT PLATE
RIVING KNIFE
y When lifting saw, hold it close to your body while
lifting. Keep knees bent and lift with your legs, not
your back.
y Fully assemble saw with stand assembly prior to
use.
y Stand assembly is an integral and necessary part of
the support structure for this saw. Do not attempt
to substitute a table or other surface for the stand
assembly.
y Do not modify saw, or create accessories not
recommended for use with this saw.
y Do not connect to power supply until assembly
is complete. Make sure power switch is in “OFF”
position before connecting to power supply.
y Avoid contact with blade teeth. Keep blade stored
or lowered when possible.
FIGURE 1
H
I
d
b
e
c