Operating Guide

FIGURE 5

FIGURE 4

STYROFOAM

NOTE: Make sure that stand part 1 (H) and stand part 2

(I) are assembled in the proper orientation.

With assembled stand open, attach legs (J) to the stand

using (eight) M8 x 35mm carriage bolts (a) and (eight)

M8 lock nuts (e). Tighten lock nuts to secure legs to

stand (Fig. 3.)

NOTE: Do not over tighten lock nuts.

See nished assembly of stand in (Fig. 4).

NOTE: Before assembling stand to saw, unlock bevel

lock, tilt blade/motor assembly and remove Styrofoam

piece from under saw motor. The bevel lock is the

handle located underneath the blade height adjustment

wheel (Fig. 5).

ASSEMBLY

FIGURE 2

CORRECT INCORRECT

H H

I I

FIGURE 3