Use and Care Manual

NOTICE: This high-quality shower door glass is tempered for safety, but it is glass and therefore, it can break. Treat it with care!

• Make sure corner protectors remain on glass during installation

• If the glass ever needs to be adjusted, make sure to put the corner protectors back on all glass panels before removing the glass, and make sure

to wear goggles and gloves

• Never allow the glass to make direct contact with hard surfaces such as ceramic tile, stone, metal or concrete

• Keep all hardware ﬁrmly tightened

• Make sure all bumpers are installed per instructions

• Avoid slamming the doors (be sure to tell the kids!)

• Never put excessive weight on the knobs or towel bars (again, tell the kids!)

• If the glass drags or does not bypass or swing out with ease, adjust the door immediately. Please see Installation Guide for directions

• Routinely check the door(s) to ensure everything is functioning as intended

• Make sure to follow all recommended care and cleaning information

Shower Door Glass Care & Cleaning

Your shower door glass panels are treated with Spot Guard, a hydrophobic coating that’s factory applied to the inside-facing glass panels to repel

water and makes it easier to clean. With regular maintenance and avoiding harsh chemicals, Spot Guard will reduce water stains, soap scum and

limescale from building up, leaving beautiful, clear glass.

While Spot Guard will help staining and buildup, it’s important to take steps to keep your glass looking clean. The following tips will help ensure

your shower door glass stays clean and beautiful.

• After showering, use a good quality squeegee to remove water from the surface

• Wipe the door dry after showering with a clean, soft microﬁber cloth, especially if you live in an area with hardwater or notice soap deposits

• Periodically clean your glass with a mild detergent or vinegar solution

• Do not use abrasive cleaners and never use bristly brushes or rough sponges

For regular cleaning use ONLY mild detergents or warm, soapy water. Use ONLY non-abrasive cloth or sponge. ALWAYS rinse surfaces after

cleaning. Before cleaning this product with cleaning products, test a small, inconspicuous area.

CAUTION: Manufacturer does not recommend the use of cleaning products that contain any of the following chemicals. Use of products contain-

ing these chemicals can cause the products to discolor and will void the warranty.

• Naphtha • Hydrogen Peroxide Solution (common household peroxide) • Toluene • Ethyl Acetate • Lye (common in drain cleaner) • Acetone

IMPORTANT GLASS SAFETY

NOTICE FOR HOMEOWNER

Spot Guard Coating

Reduces water stains,

soap scum & limescale.