Installation Guide

37
On the outer glass panel, install remaining angle blade
seal (G) on edge of glass furthest from shower head.
Align seal with TOP glass panel such that the seal will
not interfere with bottom bumper.
Angled blade of seal should orient INTO the shower as
shown.
En el panel de vidrio exterior, instale la junta de hoja en
ángulo (G) restante en el borde del vidrio más alejado del
cabezal de ducha.
Alinee la junta con la PARTE SUPERIOR del panel de
vidrio de manera que la junta no interfiera con el tope
inferior.
Como se muestra, la junta de hoja en ángulo debe
orientarse HACIA ADENTRO de la ducha.
56
G
J
Identify bumper seal (D). This component will not have a
blade.
Install bumper seal (D) to the inside edge of outer door
glass panel (J). Align seal with TOP of glass panel.
NOTE: See illustration bubble for proper orientation of
seals.
Identifique la junta del tope (D). Este componente no
tendrá una hoja.
Instale la junta del tope (D) en el borde interior del panel
de vidrio de puerta exterior (J). Alinee la junta con la
PARTE SUPERIOR del panel de vidrio.
NOTA: Consulte el detalle ampliado de la ilustración para
la orientación correcta de las juntas.
57
D
J