Installation Guide

42
TROUBLESHOOTING / SOLUCIÓN DE PROBLEMAS
Symptom: Alignment Recommended Action
1. The top track is cut too short. Top track must be cut correctly. See steps 12-14. If top track was cut incorrectly, please return to local Home Depot store
for assistance or call Delta Customer Service at 1-800-964-4850.
2. The bottom track is cut too short. Add sealant as needed to ensure watertight seal. See steps 49 and 59. If additional sealant is insufficient, please return to
local Home Depot store for assistance or call Delta Customer Service at 1-800-964-4850.
3. The glass panels do not track into the bottom bumpers. Remove bottom bumpers and reposition - See Steps 53 and 54.
Symptom: Water Leaks Recommended Action
1. Water leaks between panels. When showering, make sure the inside panel is closest to the showerhead wall.
2. Water leaks between side walls and the glass panel. Ensure all seals are in proper location and orientation. See Steps 55-58.
3. Water leaks under the bottom track. Check for proper silicone sealant application. See steps 49 and 59. Apply more silicone sealant as needed.
4. Water leaks over bottom track. Ensure that inner overhang of bottom track is free of sealant and inner panel is closest to shower head during use.
CAUTION: Do Not force the panels to move as doing so may result in breakage and risk of injury. If the following steps do not resolve the associated
symptoms or for any questions, call Customer Service at 1-800-964-4850.
Symptom: Operation (open/close) Recommended Action
1. The outside panel is difficult to move. a. Ensure sufficient clearance exists between the center divider and the glass panel. If needed, adjust the outer rollers.
See steps 40-42.
b. Ensure the panel is properly engaged within the center divider and the center guide is properly secured with self-
tapping screw. See step 52.
c. Ensure the rollers are properly installed.
d. Clean any debris in the top track where the rollers operate.
2. The inside panel is difficult to move. a. Ensure sufficient clearance exists between the center divider and the glass panel. If needed, adjust the inner rollers.
See steps 40-42.
b. Ensure the panel is properly engaged within the center divider and the center guide is properly secured with self-
tapping screw. See step 52.
c. Ensure the rollers are properly installed.
d. Clean any debris in the top track where the rollers operate.
3. Damper operation. a. Ensure dampers are in proper orientation - See step 19.
b. Ensure dampers are securely fastened. - See step 20.
c. Ensure damper catch is properly adjusted - See step 42.
d. Damper catch should reset automatically during each opening. See step 42.
Symptom: Maintenance Recommended Action
1. Excess noise or vibration. a. Check all fasteners and re-tighten as necessary.
b. Ensure bushings (II) and roller gaskets (HH) are installed in glass.
2. Track kit discoloration. Carefully review and follow Care and Cleaning Instructions.
Continued /Continuación