Installation Guide

ManualsBrandsDelta ManualsPlumbingZura 1-Handle Shower Faucet Trim Kit with H2Okinetic Spray in Stainless (Valve and Shower Head Not Included)

68881 Rev. M

Installation

Showerhead and Tub Spout Installation

FOR TUB SPOUT INSTALLATION:

Refer to the installation instructions supplied with your spout. Do not connect deck mount spouts to

in-wall valves. Do not use hand showers connected in lieu of a tub spout to a tub/shower valve. Do not

use PEX tubing for tub spout drop.

Slip-On Installation

The copper tube (1) must be 1/2” nominal

copper. Important: If it is necessary to cut the

copper tube, the end must be chamfered free of

burrs to prevent cutting or nicking O-ring inside

the spout. Slide spout over copper tube ush

with the nished tub or wall surface. Tighten set

screw (2), but do not overtighten.

Iron Pipe Installation

Install threaded pipe nipple (1) to extend past

nished wall. Apply plumber tape to threads on

pipe nipple and screw on tub spout.

Copper Sweat Installation

Install adapter so the end of the adapter is 1/4" to

1" (6 mm to 25 mm) from finished wall. Remove

O-ring (1) from adapter (2). Solder adapter to

tube taking care to keep solder away from O-ring

groove. CAUTION: NO SOLDER PERMITTED ON

OUTSIDE DIAMETER OF ADAPTER ADJACENT

TO O-RING GROOVE. Cut off tube (3) and

replace O-ring on groove of brass adapter. Thread

tub/spout onto adapter, taking care not to damage

O-ring, and hand tighten until spout is firmly

against finished wall and all slack is taken up

behind wall.

Iron Pipe Installation

Installation of easy-on universal tub spout

Install pipe nipple so that end of nipple projects out

from nished wall surface 1/2" to 1 1/4" (13 mm to

32 mm). Apply plumber tape or pipe dope to pipe

threads. Hand tighten adapter (1) onto pipe nipple

(2). Finish tightening with standard pipe wrench

until a positive seal is implemented. Take care not

to damage O-Ring (3) groove. Back of adapter (1)

must not project more than 1" (25 mm) from nished

wall surface.Hand tighten tub spout onto adapter (1)

taking care not to damage the O-Ring (3).

C-4

C-3

C-2

C-1

1/2" to 1 1/4"

(13 mm to 32 mm)

1 2

1/4" to 1"

(6 mm to 25 mm)

3 1/2" (89 mm) max.