Operating Guide

Installation
2
Showerhead and Tub Spout Installation
5
Copper Sweat Installation
Remove O-ring (1) from adapter (2). Solder
adapter to tube taking care to keep solder away
from O-ring groove. CAUTION: NO SOLDER
PERMITTED ON OUTSIDE DIAMETER OF
ADAPTER ADJACENT TO O-RING GROOVE. Cut
off tube (3) and replace O-ring on groove of brass
adapter. Thread tub/spout onto adapter, taking
care not to damage O-ring, and hand tighten until
spout is rmly against nished wall and all slack is
taken up behind wall.
B-4
1
3 2
Iron Pipe Installation
Installation of easy-on universal tub spout
Install pipe nipple so that end of nipple projects out
from nished wall surface 1/2" to 1 1/4" (13 mm to
32 mm).
Apply plumber tape or pipe dope to pipe threads.
Hand tighten adapter (1) onto pipe nipple (2).
Finish tightening with standard pipe wrench until
a positive seal is implemented. Take care not
to damage O-Ring (3) groove. Back of adapter
(1) must not project more than 1" (25 mm) from
nished wall surface.
Hand tighten tub spout onto adapter (1) taking care
not to damage the O-Ring (3).
B-3
1/2" to 1 1/4"
(13 mm to 32 mm)
1 2
3
68883 Rev. J