Installation Guide

Installation

Installation and Adjustment of the Temperature Knob

Failure to do so may cause injury.

Potential scald or thermal shock injury could result due to cross ow if outlet at the

shower is blocked or restricted (e.g., pause control on showerhead). Be sure to point

showerhead away from you when re-starting ow or install inlet check valves on both

supply lines to prevent possible injury.

A. Adjust temperature limit stop!

Turn on

water supplies; LET THE WATER RUN

AT BOTH FULL HOT AND FULL COLD

TO ENSURE THE WATER IS RUNNING

AS HOT/COLD AS POSSIBLE. Place

a thermometer in a plastic tumbler, and

hold the tumbler in the water stream.

Place the temperature knob (1) onto the

splines (2), then rotate the temperature

knob until you achieve your maximum

desired temperature from the outlet (not

more than 120° or the lower temperature

mandated by your local plumbing code).

Remove the temperature knob and replace

onto the splines (2), making sure that the

temperature knob limit stop (3) hits against

the volume handle limit stop (4) as shown.

Secure the temperature knob using screw

(1) and place cap (2) on knob.

Secure temperature control knob (1) with

screw (2). Hook (3) front of temperature

control cover (4) onto knob (1) before

engaging rear snap (5).

B-1.

B-2.

68883 Rev. G