Instruction manual

Fig. 21

Fig. 22

4. Insert knife transfer tool (G) Fig. 21, underneath

center of knife. Lift the knife transfer tool up until

knife (H) separates from pins (J) and pull out and

remove knife as shown. NOTE: Knife transfer tool is

magnetized, allowing it to attach to knife.

5. Rotate knife (H) Fig. 22 end-for-end, or using a new

knife, position knife transfer tool (G) on top of knife

as shown. Place knife in cutterhead with bevel up

underneath locking bar (D), making sure pins (J) in

cutterhead engage with holes (K) in knife.

6. Remove knife transfer tool and tighten the six

screws at (F) Fig. 23, using wrench (E) supplied.

7. Replace other knife by rotating head 180 degrees and

repeat STEPS 3 THROUGH 6.

Fig. 23