Specification Sheet

Hose Cocks
Single ball valve
3/8" M.I.P. inlet
Model No: W6200A
SPECIFICATION:
•
Ball valve hose cock(s)
•
Floating ball-type design
•
Universal 10 serration vandal resistant nozzle with 3.2mm(1/8") outlet -
removable with flat on one side
•
Forged brass non-removable vandal resistant handle (ADA compliant) -
obvious on/off positions
•
O-ring seals
•
Check piston located in nozzle to prevent contamination of service lines
and valve sealing surfaces (with exception of vacuum service)
•
Vacuum valves supplied with corrosion resistant ball and viton o'rings for
improved durability
•
Rated to maximum 125 psi testing pressure
•
Coloured index button to suit desired service
•
Maintenance free- no need to regrease sealing surfaces or take valve apart
•
10 year warranty-every ball valve carries its date of manufacture on the
underside of the body
•
Use of this ball valve above 40 psi requires special clamping procedures by
others to ensure that any hoses attached to nozzle do not blow off
•
Single ball valve, 3/8" M.I.P. inlet
•
Chrome Finish
•
Indexed For: A - Argon(White)
COMPLIES WITH:
•
CGA/AGA approved and tested to ANSI Z21.15.92 and CAN/CGA 3.16-
M88, at both high pressure (125 psi) and low (0.5 psi).
•
Meets ADA prescribed, 5 lb. force pressure requirements.
•
(Contact Delta Representative for State and/or Local Approvals)
(Dimensional drawing on following page)
•
Not Available
OPERATION:
Delta reserves the right (1) to make changes to specifications and materials, and (2) to change or discontinue models, both without notice or obligation. Dimensions are for reference.
Measurement may vary plus or minus 6mm(0.25"). Mounting locations are suggested only. Check with local codes for requirements in your area.
- 1.0.16656
Page of1 2
Delta Faucet Company - 55 East 111th St. - Indianapolis, Indiana, USA 46280 - [phone]
Delta Faucet Canada - 395 Matheson Blvd E - Mississauga, Ontario, Canada L4Z 2H2 - [phone]