User Manual

DELTANODE FIBER DAS MANUAL
©DeltaNode Solutions 2012
38
Revision 12-03
4 Installation guidelines
WARNING
This is NOT a consumer device.
It is design for installation by FCC LICENSEES and QUALIFIED INSTALLERS. You MUST have an FCC
LICENSE or express consent of an FCC licensee to operate this device. You MUST register Class B signal
boosters (as defined in 47 CFR 90.219) online at www.fcc.gov/signal-boosters/registration. Unauthorized
use may result in significant forfeiture penalties, including penalties in excess of $100,000 for each
continuing violation.
For CMRS 817-824MHz Applications:
WARNING
This is NOT a consumer device.
It is design for installation by FCC LICENSEES and QUALIFIED INSTALLERS. You MUST have an FCC
LICENSE or express consent of an FCC licensee to operate this device. Unauthorized use may result in
significant forfeiture penalties, including penalties in excess of $100,000 for each continuing violation.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference and (2) this device must accept any interference
received, including interference that may cause undesired operation.
4.1 Health and Safety
Deltanode DAS system is an advanced system and should be handled by skilled staff. Deltanode are
happy to offer training of installation service providers in the case this is necessary.
Read all available documentation and warnings before handling the equipment. Equipment failures due
to improper handling are normally not covered by the product warranty.
Respect all warning signs on the equipment and in the documentation. Make sure to only operate the
equipment on frequencies allowed to use. Do not modify the equipment. The equipment contains a Class
3B laser and the equipment is Class 1. Do never look into the Laser beam directly or indirectly, it is strong
invisible light and may cause serious damage to human eyes.
Always use protective hat on fiber and connector end when fiber is removed from socket. Always clean
socket and connector after a fiber has been removed before you re-attach it again.
Make sure to keep passwords and other operational information away from unauthorized personnel.