User's Manual

FiberDistributedAntennaSystem(FiberDAS)
95
System Commissioning
Pre-requisites
 EstablishEthernetconnectionbetweentheBGWandallcards
 Powerupallequipment
 EnsureIPaddresseshavebeenassigned
Cardswillbri
eflyflashgreen.SolidgreenindicateswaitingforIPassignment
 VerifyremoteunitfibersareconnectedtocorrectFOIports
 Setnamesforallcomponentsandaddcomponentstothesystem‐See“NamingComponents”section
 ConnectBTStotheBIUensuringproperattenuationfortheBIUcardbeingused
Commissioning Process
1. Oncethefiberisconnectedandverified,turnFOIRFpoweron.
Connectonlyonefibe
rportatatimeandcompletenamingofremote.Otherwise,asecondpersonwillbe
neededattheremotestoidentifytheremotewhen“LocateMe”isenabled.Thiscanbeeliminatedwithgood
projectmanagementandlabelingduringtheinstallationprocess.
Figure 108
FOI
RF
Control
FOI RF On
2. Enabletheappropriateopticalportsonthe4‐portFOI
Onlyenabletheoptic
alportsthatarebeingused.Otherwise,thesystemwillalarmwithlowopticallevelson
theunusedports.