User's Manual
Table Of Contents
- Safety Precautions
- About This Manual
- Table of Contents
- Chapter 1 Introduction
- Chapter 2 System Description
- Chapter 3 Installation guidelines
- Chapter 4 DAS Software Configuration
- Chapter 5 Commissioning
- Chapter 6 RF Commissioning
- Chapter 7 Model Identification
FiberDistributedAntennaSystem(FiberDAS)
91
Figure 105 Unit Naming
6. GotoAdvanced>Applrestart.
7. SelecttheRe
booticonatthebottomofthemenu.See
Figure106
.
8. Select"YES‐Res
tartProcess"
Note: Afterrebooting,itca
ntakeupto5minutesbeforetheunitshowsupintheGUI.
Figure 106 Naming Reboot
9. Afteralltheunitshavebeenrenamed,gototheConfigurationmenuandselectthecorrectcardtype.
10. Highlightallthecard
sintherightcolumnthathadnamechangesandthenselect“<<“.Select“Submit”
Thiswillr
emovetheoldnamesfromtheDASConfiguration.
11. Highlightallthecard
sintheleftcolumnwiththenewnamesandthenselect“>>”.Select“Submit”.
Thiswillmov
ethenewcardnamesintotheDASconfiguration.
Table 67 Submit Newly Named Units
12. SelectNetworkViews>Alltoconfirmthatallcardsarenowpartoftheconfiguration.