User Guide

10. With an assistant, slide base plate up onto frame and

forward to bumper make sure horn bolt hole and air

box holes line up, then clamp.

11. Drill bottom two 3/8” holes (on each side) insert bolts

and tighten, drill top two 3/8” holes (on each side)

place spacer bushings on each as shown on front

cover with the longer spacers on the drivers side and

the shorter spacers on the passenger side. NOTE:

Use Blue on threads and tighten bolts

according to bolt chart on front page.

12. Drill two 3/8” holes in bumper using base plate chain anchor

as a guide insert bolts and tighten (use shims if needed).

13. Notch plastic filler panel as shown in picture on each side

and replace.

14. Notch plastic on front facia for pull ears as shown above.

Reinstall facia, plastic filler panels and all hardware. Install

horn with longer supplied metric bolt, washer, and

lockwasher.

Drivers side

Passenger side