- Dethmers Manufacturing Company Automobile Accessories User Manual

7. Install right and left frame mounts. Put proper side up and push 7/16” bolt through hole

and start 7/16” lockwasher, and hex nut. Start 10mm x 1.25 punch lock nut over factory

stud. Push mount up so angle is ﬂ at on front of frame, and clamp with C-clamp. Snug

previously mentioned fasteners. Drill 5/16” holes through frame using mount as a template

(three on each mount).

8. Remove top bumper bolt on each side and install brace with 8mm x 1.25 x 25mm

bolt, 8mm lockwasher, and 8mm fender washer. Secure bottom of brace to frame

mount using 3/8” x 1-1/4” bolt, 3/8” lockwasher,3/8” ﬂ atwasher, and 3/8” hex nut.

We require that “

Blue” be used on all bolts.