User Guide

3
■ For indoor use only.
■ Do not place near hot gas or electric burner.
■ To disconnect, turn the control to “off” before removing
the plug from the outlet.
■ To reduce the hazards of potential shock, the
dehydrator has a polarized plug (one blade is wider
than the other), which will fit only one way in a
polarized outlet. If the plug does not fit, contact a
qualified electrician for assistance. Do not attempt to
defeat this safety feature.
■ Do not clean with metal scrubbing pads. Pieces can
break off the pad and short-circuit electrical parts,
creating a possibility of an electrical shock and
damaging the unit.
■ To protect against electrical shock, do not immerse
plug, cord or motor base in water or any other liquid.
■ It is recommended that you do not use an extension
cord with this dehydrator. However, if one is used, it
must have a rating equal to or exceeding the rating of
this appliance.
■ This dehydrator is for household use only.
■ This dehydrator should not be used for other than its
intended use.
■ If you suspect your food is contaminated, do not eat it.
IMPORTANT SAFEGUARDS
When using this electrical appliance, safety
precautions should always be observed,
including the following:
■ Read all of the instructions before using, then save for
future reference.
■ Do not let the cord hang over the edge of the work
space or touch any hot surfaces.
■ Place the dehydrator securely in the center of the
counter or work space.
■ Close adult supervision must be provided when this
appliance is used by or near children.
■ Using attachments not recommended or sold by
Deni/Keystone Manufacturing Co., Inc. may be
hazardous.
■ Do not operate the dehydrator on a non-heat resis-
tant glass, or wood cooking surface or any tablecloth.
It is imperative that a heat resistant cooking surface
with heat resistant finish be placed beneath this unit.
■ Do not operate with a damaged cord. Return the
dehydrator to the repair center or have it repaired by a
licensed electrician.
■ Always unplug before cleaning and removing parts.
Allow unit to cool before putting on or taking off parts.
7100 Instructions sgle pg 6/18/01 9:46 AM Page 4