Specifications

Master Page l
“ The Pro’s Choice” 53
Original Snap-In Safety Pads l
“ The Pro’s Choice” 53
View of Snap-In Kevlar
®
/Polyester Pad
Protection on the Inside of Pants
ORIGINAL SNAP-IN SAFETY PADS are
worn on the inside of your pants. They
require special pants fitted with upper snaps
and knee-pockets (see below) or can be
sewn into regular work jeans.
Many timber fallers prefer this type of leg
protection because it allows more freedom
of movement than chaps worn on the out-
side. With outside chaps, straps and buck-
les add weight and can get hung up on
brush. Inside chaps are lighter and require
no straps or buckles because they are held
in place by the pants.
Like outside chaps, SAFETY PADS are not
represented as shields against damage, but
as an aid to help prevent more severe damage
in extreme cases.
What size safety pads do you wear?
• Regular length is for people up to about 6'.
• Tall is for long legged people or over 6'.
Note: Safety pads should extend from
the waist to the top of the foot.
Knee-sleeves and snaps have
been added to these logger's
jeans so they can be used with
Labonville snap-in safety pads.
If the pants are cut into, the
knee sleeves help hold the
safety pads in place to protect
the legs. The snaps also make it
easy to remove the pads for
laundering or for swapping into
another pair of jeans.
Cut away side
view of pad in
safet y pants .
Note sleeve in
knee area and
snaps on top.
Shown is the front view of a
pair of single snap safety pads.
Price includes both chaps.
Jeans for Snap-In
Safety Pads
See the Madsen’s
Jean listing on
page 67 for sizes.
See page 52 for insu-
lated winter pants and
cool knit polyester
summer pants that
accept these cut resis-
tant pads.
Labonville Snap-In Safety Pads
MADSEN’S
1-3 36
95
4+ 34
95
#SP500KPR
Regular Length 39
00
32
95
30
95
#SP500KPL
Tall Length 42
00
34
95
32
95
Size List MADSEN'S
1-3 4+