Instruction manual
10
G-Series SP20004_REV_2
As an indication coins measure the following:-
- 1p 1.58mm (0.063” ) - 2p 1.80mm (0.071” ) - 5p 1.73mm (0.067” )
- 10p 1.84mm (0.072” ) - 50p 1.84mm (0.072” ) - £1.00 3.14mm (0.124” )
Remember height of cut is effected by moisture of turf , weight of machine and the
thatch density. Different makes of machine cut at different heights when set to the
same position with the setting bar. We suggest you set it to a couple of mm above your
planned height and then come down in height by trial.
Always check height of cut/operation with the setting bar provided. Check in two
positions i.e. one at either end of the cassette. Failure to do this could result in an
uneven cut.
General Adjustments
6(77,1*)25+(,*+72)&87
Always stop the engine before adjusting the height
of cut. Failure to do this may result in serious injury.
The length of grass after cutting and the depth of
scari¿cation / dethatching / brushing, depends on
the setting of the front roller in relation to the main
frame of the machine.
7RVHW
Slacken the clamp nuts on the front roller
quadrants (Item 1) [19mm spammer].
Rotate the quadrants, raising and lowering the
machine. As a guide, there are notches in the quadrant and holes in the side plate. Align these on both sides to level
the machine.
XX
560
DO NOT ATTEMPT TO USE THE DETHATCHING CASSETTES OR BRUSH CASSETTES
ON TOO LOW A SETTING AS THIS WILL RESULT IN DAMAGE TO THE BLADES AND
BRUSHES.
NOTE
DO NOT ATTEMPT TO SCARIFY ON TOO LOW A SETTING WHEN THE GROUND
CONDITIONS ARE DRY AS THIS MAY CAUSE THE CLUTCH TO SLIP.
NOTE
To check the height of cut and that the machine is level a setting bar (229524) can be used. Place the bar between the
front and rear rollers, resting the underside of the bolt head on the lip of the shear blade.
Either a ruler or pile of coins can be used to set the setting bar to the correct position. You are measuring the distance
between the bar and the underside of the button head screw (‘XX’ in the Image below).
,WHP