Instruction manual

11
G-Series SP20004_REV_2
General Adjustments
6(77,1*7+(&</,1'(5
The cylinder cassette can be set either in or out
of the machine. To remove the cassette see
page 12.
7RVHW
 Slacken 2-off lock nuts (item 1)
[19mm spanner]
 Rotate nut (item 2) anti-clockwise to bring the
blade towards the cylinder.
 Check the setting using thin paper along the
length of the cylinder.
 Adjust until it cuts along the whole length.
 When set, tighten the lock nut (item 1)
 Recheck adjustment.
 '2127 set the cylinder hard to the bottom blade. This will cause excessive wear of both components and increase
fuel consumption.
+$1'/(%$5$'-8670(17
The “Handle Bars” are adjustable to acheieve the
correct working height for the operator.
7RVHW
 Slacken 4-off nuts (Item 1) 1/4” turn
[17mm Spanner]
 Raise / lower the _Handle Bar_ to the desired
position
 When set, tighten the nuts (Item 1)
,WHP
,WHP
H
,WHP