Instruction manual
12
G-Series SP20004_REV_2
5HPRYLQJ7KH&DVVHWWH8QLW
To remove the cassette unit for maintenance or to
exchange cassettes the following procedure should
be followed:-
1) Unscrew the bolt (Item 1) [24mm Spanner] for
about half-an-inch (13mm) until the pip end is
inside the nut on the side frame.
2) Slide the cassette unit along the tie bars as far
as it will go until the cutter nut and coupling is
clear of the three pins in the driving coupling.
3) Remove the unit from the chassis by lifting in a swinging motion from the back.
To replace the cassette unit :-
1) Place the front slots of the cassette unit frames on the two front retaining pins seen
projecting from inside each frame.
2) Carefully lower the unit in a downward swinging motion until the rear slots of the
cassette unit frame rest on the cross tie bar.
3) Move in a lateral direction away from the retaining pin until the three holes of the
cassette nut and coupling are in full engagement with the three pins of the driving
coupling.
4) Screw up the bolt (Item 1) [24mm Spanner], engaging the hole in the side frame
on the opposite side. Do not over tighten.
D
,WHP