Instruction manual

G-Series SP20004_REV_2

Routine Maintenance

&</,1'(5&/87&+

The Cylinder drive belts are shown in ¿g 2 (item 2).

There are special Kevlar V belts ¿tted in pairs and

designed for clutching applications. The cylinder

clutch pulley moves into tension the belt via a

control cable. The tension in the cable can be

adjusted as shown in ¿g 2 [13mm spanner].

Under tensioning this belt will lead to slip and

cause rapid wear. Over tension will put excessive

stain on the belt and bearings.

&$%/($'-8670(17

Over time the cables that operate the clutch pulleys and the brake will need adjusting. This adjustment can be carried out

at either end of the cables [10mm spanner].

NEITHER CLUTCHES OR BRAKE SHOULD OPERATE WITH THE CONTROLS IN THE

OFF POSITION.

NOTE

,WHP

Cylinder

&OXWFK

Fig

ENSURE THE LOCK NUTS ARE TIGHT AND SECURE AND CHECK OPERATION IS

SATISFACTORY BEFORE REPLACING THE CLUTCH COVER AND SCREWS.

NOTE

Storage

The machine should always be kept in a clean dry place, free from condensation. After use ensure that the machine is

thoroughly clean, dry and free from grass and mud. Before off season storage smear a thin layer of grease on to the

cutter blades and the shear blade.

Under no circumstances must the machine be steam cleaned as this may remove grease from the pre packed bearings.

Because of the nature of lead free petrol we recomend that if the machine is being left unused for more than 2 weeks the

carburetor is run dry. Allow the engine to run out of fuel with the fuel tap switched off.